Spo2 Simulator
OXSIM - Pulse Oximetry Tester
|
The OxSim is the perfect complement to the SimCube family. It is Optical tests the whole system, including the sensor, pocket sized and runs on one AA alkaline battery for 10 hours 4 Oxygen saturations, 3 pulse rates and a low perfusion mode all at the touch of a button make it an indispensable tool for any biomed. OxSim is small enough to fit right into your SimCube carrying case and can be run off the same battery boost option as your SimCube, simultaneously
|
|
|
 |
 |
 |
A single Mode button toggles between modes with different saturation values, different heart rates, and different perfusion levels. |
|
A single probe Type button toggles through R-curves for different brands of oximeter probes, though most are automatically detected by OxSim. No complicated software menu to navigate, searching for ma |
|
Small enough to fit in your shirt pocket. Dimensions: 2-1/4 X 2-1/2 X 1-1/4 not including finger section |
|
Provides 8 hours of continuous simulation time on a single AA battery. |
|
Optical simulation means there are no adapter cables to purchase or carry, and that you test the whole system, including the sensor. |
|
Tested for ruggedness--over 50 drops with no failures |
|
|
|
Simulation Accuracy Saturation Error Error in the displayed saturation value should be less than or equal to the specified error of the sensor which is typically +/- 2%, but which can be +/-3% or more for some disposable sensors. Heart Rate Error Less than 1 bpm Modes of Operation 85% Saturation 85% Pulse Rate 80 bpm Perfusion Index 2.0 95% Saturation 95% Pulse Rate 40 bpm Perfusion Index 2.0 98% Saturation 98% Pulse Rate 80 bpm Perfusion Index 2.0 140 BPM Saturation 98% Pulse Rate 140 bpm Perfusion Index 2.0 Low Perfusion Saturation 99% Pulse Rate 80 bpm Perfusion Index 0.2 Sensor Type Selection Nell/Mas Used for: All Nellcor, Masimo, Datascope, Protocol, Spacelabs, HP/Philips (blue extension cable), HP/Philips (tan soft sensor), Nihon Kohden, Colin, GE/Marquette, Welch Allyn HP/Ohm Used for: HP cocoa brown soft sensor, Ohmeda and Novametrix |
Physical Dimensions Size 2.5'' x 2.5'' x 1.25'' (excluding finger) Weight 5 ounces (excluding battery) SpO2 Connection Optical Power Battery 1 AA battery (any chemistry) Power Battery Life (Alkaline) 8 to 10 hours of simulation time (typical, depending on the oximeters under test) 60 days in sleep mode (unit sleeps after 10 min. with no probe connection) AC operation Included 6V DC supply operates over 100-240 VAC, 50-60 Hz |
|
|
 |
|
 |
